Siemens Rack PC 840 V2 Mise En Route page 38

Annexe
9.2 Certificats et homologations
CEM
Etats-Unis
Federal Communications
Commission
Radio Frequency
Interference Statement
Shielded Cables
Modifications
Conditions of Operations
CANADA
Canadian Notice
Avis Canadien
9-4
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES–003.
Cet appareil numérique de la classe A est conforme à la norme NMB–003
du Canada.
SIMATIC Rack PC 840 V2
Mise en route, Edition 04/2004, A5E00248070-02