Synchronisation; Operation; General Information - Zephyr ARC Serie Notice D'utilisation

2.1 S
ynchroniSation
To synchronise the remote control with the range hood for the first time, proceed as follows:
1. With range hood off, press and hold the "light" button on the range hood until the light
indicator begins to flash (approximately 3 seconds). Fig.1
2. Rotate the remote top until the light indicator on the remote illuminates. Push down on the
remote until the lights on the hood turn on. Fig.2
The range hood may now be activated using the remote control. If you experience any problems,
repeat the procedure.
2.2 o :
peration
- BLOWER SPEED
Adjust blower speed by rotating the remote top until the desired speed level indicator is
illuminated. Push down on the remote to activate the selected blower speed level. Fig.3
= Blower Off
1 = Low
2 = Medium
3 = Hight
- LIGHTS:
Adjust lights level by rotating the remote top until the lights indicator illuminates. Push down on
the remote to active the lights. Push once for bright, twice for normal, three times for dim and a
fourth time to switch the lights off. Fig.2
1
2.3 G i
eneral nformation
- The remote control has a range of approximately 15 feet.
- The remote control is equipped with a magnetic base and may be attached to ferrous surface for
easy storage.
- The remote top is made of a plastic material and is prone to scratches, Use care when handling and
cleaning the remote; we suggest using a microfiber cloth to clean it.
- BATTERY REPLACEMENT:
The batteries will last approximately 12-15 months, depending on usage.
1. Remove rubber cover from bottom of remote. Fig.4
2. Using a Philips head screwdriver, remove the screws securing the bottom plate to remote body.
Fig.5A Pull up to remove bottom plate and remote body from remote top. Fig.5B
3. Press on the metal spring located in the battery tray to dislodge battery. Replace both batteries with
type 3V CR2032. Fig.6 Re-assemble by following instructions in reverse.
4
:
2
:
A
B
5
- 7 -
www.zephyronline.com
3
6