Safety; 4�1 Explanation Of Symbols - Hauff-Technik GFH 30 Instructions D'installation

GFH 30
4

Safety

This section provides an overview of all the main safety aspects for optimum protection of personnel
and a safe installation process.
If there is a failure to observe the instructions and safety information set out here, this may result in
significant hazards.
When installing the GFH 30 it is imperative to observe the relevant professional association rules, the
VDE provisions, the relevant national safety and accident prevention regulations and your company's
guidelines (work and procedure instructions).
The fitter must wear the relevant protective clothing.
Only intact components may be installed.
The following points must be rigorously observed when handling expansion resin:
Expansion resin: Tangit M 3000
Component B:
contains isocyanate.
Please observe the latest version of the instructions and safety data sheet issued by the
manufacturer.
Of reduced toxicity.
Contains methylene diphenyl diisocyanate, isomers and homologues.
• Harmful to health when inhaled
• Irritates the eyes, breathing organs and skin
• Sensitisation possible through inhalation
• Keep out of reach of children
• In the event of contact with eyes, rinse thoroughly with water and consult doctor
• In the event of contact with skin, wash off immediately with plenty of water and soap
• Wear protective gloves
• In the event of accident or sickness, consult a doctor (show the label of the resin cartridge if
possible)
• Processing temperature: +5°C bis +30°C; optimum: +15°C to +25°C
4�1 Explanation of symbols
1
Work stages
►
Effect/result of a work step
1
Reference numerals in drawings
Art. Nr.: 5090033079 Rev.: 01/2018-09-04
EN
19