Klarstein Charleston Mode D'emploi page 11

4
Connect wires from
supply and bracket to
the wiring terminals as
follow:
Brown wire: "L"
Blue wire: "N"
Green/Yellow wire:
7
Assemble blade clips
onto the blades by
tightening the screws,
flat washer,
spring washers and
nuts together.
5
Attach canopy to the
bracket by aligning
canopy side holes
with the bracket side
holes. Lift fan until
the screws reach the
bottom of the slots and
then rotate the canopy
counterclockwise
until the screws
drop into the slot
recesses.
8
Install the fan blade
sets onto the motor by
tightening the screws
and spring washers
6
Insert the other two set
screws and washers.
Tighten all the screws,
make sure that the
canopy is secure and
that you have not
trapped any wires.
Ensure that the slot of the
nylon ball hanger fits
into the guide pin of the
upper canopy.
9
Insert the male
connector into the
female connector
securely as shown.
EN
11