BIG RED JACKS TRF42009 Manuel page 7

LOWERING THE HOIST STAND
1. Ensure that all tools, equipment and personnel
are clear before lowering load.
2. DO NOT EVER LOWER STAND UNLESS
VEHICLE AND COMPNENTS ARE 100%
SUPPORTED SECURELY. DO NOT EVER
ASSUME LOAD IS SECURE, CHECK BEFORE
LOWERING.
3. With vehicle securely supported on car lift, lower
stand clear of support point.
4. Carefully release stop pin and allow pillar to glide
down to lowest position, re-insert stop pin.
5. Carefully remove stand, then carefully lower
vehicle on car lift.
LUBRICATION
A periodic coating of light lubricating oil to pivot
points will help to ensure that pump piston linkages
move freely.
Note: Never apply oil to the saddle. If saddle
extension threads require lubrication; clean thread
surfaces with a clean, dry cloth, then apply a drop of
bearing grease to the threads. Distribute as evenly
as possible along the threaded post.
7