Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Use the exploded drawing as your guide to assemble, Lay all parts and assemblies out in front of you
before beginning. The following procedure is recommended:
All numbers in parenthesis () refer to the index number from the parts breakdown.
1. Mount the rubber pad (NO.23) with the saddle
(NO.22), use screw (NO.24).
2. Connect the guide plate (NO.7) to the L-brackets
(NO.8) with screws (NO.6), washers (NO.4) and
nuts (NO.5), but do not tighten the screws.
3. Attach the short pull rods (NO.13) and the long
pull rods (NO.14) with the support bars (NO.3),
using the screws (NO.12) and washers (NO.10).
4. Attach the saddle base (NO.2) with the support
bars (NO.3), using the screws (NO.1), washers
(NO.4) and the nuts (NO.5).
4
Publicité
