Steinbach Active Balls 50 Notice Originale page 32

Preparing the filter vessel
1. Remove the locking ring
2. Put aside the locking ring and its wing nut.
3. Screw the riser pipe
4
4. Position the riser pipe including screen
Make sure that the protrusion in the middle of the filter vessel bottom fits into the recess of the
screen.
5. Fill the filter vessel
6
Please refer to the section "Technical data" for the required quantities.
6. Insert the vessel seal
is fitted correctly.
7. Align the notch on the outer edge of the filter
cover with the adjustment lug of the filter
1
vessel.
8. Place the filter cover on the filter vessel.
Make sure that the riser pipe
into the recess at the bottom of the filter
cover.
9. Place the locking ring
cover and filter vessel connecting point.
10. Insert the locking ring bolt
hexagon socket of the locking ring.
11. Pass the locking ring bolt through the hole on
the opposite side of the clamping ring.
12. Place the wing nut
5
turn it clockwise to tighten it.
13. Remove the bleeder screw
14. Wrap the manometer thread
tape.
15. Screw in the manometer at the removal
position of the bleeder screw by turning it
clockwise.
The filter vessel is prepared.
32
by unscrewing the wing nut
2
onto the screen .
7 8
5
7
8
in the middle of the filter vessel bottom.
8
with Steinbach filter balls.
. Check for any foreign objects in the groove and make sure that the seal
3
is inserted
7
around the filter
2
into the
4
onto the thread and
on the filter cover by turning it counterclockwise.
28
with Teflon
20
counterclockwise.
5
6
2
4
1
7
20
3
5