Fujitsu LIFEBOOK AH531 Mode D'emploi page 88

Problem
The notebook turned on
with a series of beeps and
the built-in display is blank.
The display goes blank by
itself after you have been
using it.
Your display won't turn on
when the system is turned
on or when it has resumed.
The display does not close.
The display has bright or
dark spots.
Possible Cause Possible Solutions
Power On Self Test has Contact your support representative.
detected a failure which
does not allow the dis-
play to operate.
The notebook has gone Press any button on the keyboard, or move the mouse to restore
into Video timeout, operation. If that fails, push the Power/Suspend/Resume button.
Standby, or Save-to- Check your power management settings, or close your applica-
Disk mode because you tions and go to the Power Savings menu of the setup utility to
have not used it for a adjust the timeout values to better suit your operation needs. See
period of time. "BIOS Setup Utility" on page 39.
Power management Press any button on the keyboard, or move the mouse to restore
timeouts may be set for operation. If that fails, push the Power/Suspend/Resume button.
short intervals and you (The display may be shut off by Standby Mode, Auto Suspend or
didn't notice the display Video Timeout)
come on and go off.
The system may be Check the status indicator panel to verify that the Security icon is
password-protected. blinking. If it is blinking, enter your password.
A small object such as a Remove all foreign objects from the keyboard.
paper clip is stuck
between the display
and keyboard.
If the spots are tiny and This is normal; do nothing.
few, this is normal for a
large LCD display.
If the spots are numer- Display is faulty; contact your support representative.
ous or large enough to
interfere with your oper-
ation needs.
82 - Troubleshooting