Installation Procedure - IntesisHome MH-RC-WIFI-1 Guide D'utilisation

IntesisHome MH-RC-WIFI-1
®

2. Installation procedure

Installation process should only be performed by an
authorized installer.
Please follow all Safety Instructions provided by the Mitsubishi Heavy Industries service manual
and/or installation manual.
There are two installation options available: With Control Panel and without Control Panel.
2.1 With Control Panel (Recommended)
This method assumes that you want to control the Mitsubishi Heavy Industries system both with
IntesisHome and the Mitsubishi Heavy Industries Control Panel.
1. Unplug the Mitsubishi Heavy Industries system from mains electricity.
2. Open the top lid of the IntesisHome device and remove IntesisHome's Top Hole cover.
3. Connect one end of Mitsubishi Heavy Industries's bus cable into IntesisHome device K1 connector.
4. Connect the other end of Mitsubishi Heavy Industries's bus cable into Mitsubishi Heavy
Industries's Indoor Unit XY connector or Remote Control Wiring (see www.intesishome.com/
docs/MH-RC-WIFI-1-Install_sketch.pdf for more information).
5. Connect another cable from Mitsubishi Heavy Industries's Control Panel connector to Mitsubishi
Heavy Industries's Indoor Unit XY connector or Remote Control Wiring (see www.intesishome.
com/docs/MH-RC-WIFI-1-Install_sketch.pdf for more information).
6. Configure the IntesisHome switches
Wi-Fi Router or
Access Point
4
(www.intesishome.com/docs/MH-RC-WIFI-1-Install_sketch.pdf).
X Y
3 m
K1
INSTALLATION GUIDE
# 1
X
Y
. . .
X
# n
Y