Use Of Programmes - Zehnder Alura LCD Manuel

3.4 Use of programmes

EN
The control panel on your appliance includes three non-modifiable programmes
P1, P2 & P3 which you can access by pressing the MODE key. They are based on dif-
ferent room occupation scenarios which alternate the switching of your appliance from
Comfort mode to Eco mode depending on the time. You therefore need to set the time
before making any programme mode selection.
An additional weekly user programme (
preferred operation for each day and hour of the week.
DAIly PrOgrAmmE P1
This programme can be selected when you need to heat your
room from 5 am to 11 pm (e.g. permanent presence).
DAIly PrOgrAmmE P2
This programme can be selected when you need to heat your
room from 5 am to 9 am and from 5 pm to 11 pm (e.g. work day).
DAIly PrOgrAmmE P3
This programme can be selected when you need to heat your
room from 5 am to 9 am, from 12 pm to 2 pm and from 5 pm to 11 pm
(e.g. work day with lunch break at home).
WEEKly USEr PrOgrAmmE
The user programme allows you to define your appliance's performance in detail
for every hour of every day of the week. If you select this programme, it will repeat every
week.
If no programme has been created, the appliance will operate in the default ECO
mode.
36
) allows you to specify your own
40008126
CONFIgUrINg ThE USEr PrOgrAmmE:
rEmINDEr: The clock must be set before configuring a user programme (see
chapters 4.1 and 4.2).
There is a 3-stage programming process:
- select a day to be programmed;
- define operating mode allocated to each hour of this day;
- confirm this day's programme and select another if required.
), press the MODE key for 5 seconds
From this screen (
to access the configuration screen, where you can create your cus-
tomized programme.
Pressing the MODE key again for 5 seconds at this confi-
guration stage will return you to the UP screen.
Stage 1: select day to programme
The screen displays the day and the cursor at the left
moves to the day and blinks.
Press – or + key to move to the previous or the next day.
At the desired day, press the MODE key to specify how the
appliance will operate during that day (stage 2).
ImPOrTANT:
Pressing for 2 seconds on the + key copies the
programme for the selected day to the next day.
The display then shows the day to which the programme
has been copied.
This operation only takes place from stage 1.
40008126
EN
Using your appliance 37