General Description - Gewiss Easy Manuel D'installation Et D'emploi

The Easy 1 channel 6 A motor command actuator controls the movement of motorised
shutters, curtains and blinds. 2 output relays, one for UP and one for DOWN movements,
are interlocked to avoid damage to the connected motor.
The movement commands can be accessed through Home Automation control or sensor
devices using the KNX bus, or they can be generated locally using the two front buttons.
The actuator is powered by the bus line and is fitted with 2 front green LEDs which indicate
the shutter movement status (UP/DOWN).
The actuator can function in shutter or blind mode, and is capable of handling actuation
following priority, scene and alarm commands. This device sends the bus information on
the relay status (ON = contact closed, OFF = contact open) when it is switched on, on
receiving a command and when it is activated manually.
The operating methods can be used simultaneously.
The actuator is fitted inside a standard flush-mounted box, in the space of two Chorus
modules.
The motor actuator is able to handle movement, alarm and priority commands
simultaneously. When more than one mode is activated at the same time, the actuator
will enable the one with highest priority status.
The priority of the various functions, from maximum to minimum, is as follows:
• Relay status on loss of power to the bus
• Priority controls
• Alarms control
• Relay status on reinstatement of power to the bus
• Shutters/blinds movement, scene management
The two green status indicator LEDs light up when the contacts with the respective relays
are closed.
SHUTTER MOVEMENT HANDLING
It raises or lowers the shutters, or stops the movement when it receives the relative
command.
If the Stop command is not sent, the motor will only stop at the end of the Movement Time:
The shutters must therefore be fitted with stroke end sensors or an autonomous clutch.

GENERAL DESCRIPTION

Summary
Functions
17
MAX PRIORITY
MIN PRIORITY
E
N
G
L
I
S
H