Velleman HQ-POWER Alison II Notice D'emploi page 7

function
play <PLAY>
manual <Man>
control
display <dISP>
colour change <CoLo>
pan range <oPAn>
reset <rEST>
c. DMX Mode
This mode allows you to control the fixture by any universal DMX controller.
• All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to "listen" to the DMX
controller. The same starting address can be used for a whole group of devices or an individual address can
be set for every device.
• When all devices have the same address, all the units will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will "listen" to a separate channel number. Changing the settings of
one channel will only affect the device in question.
• In case of the 12-channel VDPL501MHS10, you will have to set the start address of the first unit to 1
(CH1~12), the second unit to 13 (1 + 12) (CH13~24), the third to 25 (13 + 12) (CH25~36), and so on.
• Press <MODE> until <Addr> is displayed.
• Use <UP> or <DOWN> to set the DMX starting address (A001~A512). Press <Enter> to confirm.
d. DMX Channel Values
channel function
1 pan
2 tilt
3 pan fine
4 tilt fine
5 focus
6 shutter/strobe
7 dimmer
8 colour
V. 01 – 30/01/2012
VDPL501MHS10
display description
<Auto> auto program
<Soun> sound controlled mode
<dnCo> DMX controlled mode
<SLAE> slave mode
<CH01> <d000> Select the setting for each channel.
<CH12> <d255>
<No> normal display
<Yes> 180° rotated display
<No> colour change in steps
<Yes> colour change gradual
540 maximum pan range 540°
450 maximum pan range 450°
<FACt> Press <Enter> for 5 seconds to reset all settings except the
DMX starting address.
<Moto> Press <Enter> for 5 seconds to reset all settings including the
DMX starting address.
from to
0 255
0 255
0 255
0 255
0 255
0 0
1 239
240 246
247 247
248 255
0 255
1 17
18 35
36 53
54 71
72 89
description
rotate head horizontally (127 = neutral)
move head vertically (127 = neutral)
rotate head horizontally – small increments
move head vertically – small increments
focus
shutter open
strobe slow -> fast
shutter closed, device resets after 5 seconds
shutter open, device resets after 5 seconds
shutter open
master dimmer, 0-100%
fixed colour
white
rose
blue
yellow
green
7 ©Velleman nv