LG F4J Serie Manuel Du Propriétaire page 44

Symptoms
Dry problem
Odor
Your home
appliance and
smartphone is not
connected to the
Wi-Fi network.
44
Reason
Check water supply tap.
This odor is caused by the rubber
attached to the washing machine.
If the rubber door gasket and door
seal area are not cleaned regularly,
odors can occur from mold or
foreign substances.
Odors can occur if foreign
substances are left in the drainage
pump filter.
Odors can occur if the drainage
hose is not properly installed,
causing siphoning (water flowing
back inside the washing machine).
Using the dry function, odors can
occur from lint and other laundry
matter sticking to the heater. (Dryer
model only)
A particular odor can occur from
drying wet clothes with hot air.
(Dryer model only)
The password for the Wi-Fi
that you are trying to connect
to is incorrect.
Mobile data for your
smartphone is turned on.
The wireless network name
(SSID) is set incorrectly.
The router frequency is not
2.4 GHz.
The distance between the
appliance and the router is
too far.
Solution
• Do not overload. Check that the
washing machine is draining properly
to extract adequate water from the
load. Clothes load is too small to
tumble properly. Add a few towels.
• Turn off water supply tap.
• It is the normal odor of new rubber
and will disappear after the machine
has been run a few times.
• Be sure to clean the gasket and
door seal regularly and check under
the door seal for small items when
unloading the washer.
• Be sure to clean the drainage pump
filter regularly.
• When installing the drainage hose,
be sure that it doesn't become kinked
or blocked.
• This is not a malfunction.
• The odor will disappear after a short
while.
• Find the Wi-Fi network connected to your
smartphone and remove it, then register
your appliance on LG SmartThinQ.
• Turn off the Mobile data of your
smartphone and register the appliance
using the Wi-Fi network.
• The wireless network name (SSID)
should be a combination of English
letters and numbers. (Do not use special
characters.)
• Only a 2.4 GHz router frequency is
supported. Set the wireless router to 2.4
GHz and connect the appliance to the
wireless router. To check the router
frequency, check with your Internet
service provider or the router
manufacturer.
• If the distance between the appliance
and the router is too far, the signal may
be weak and the connection may not be
configured correctly. Move the location of
the router so that it is closer to the
appliance.
EN