LG F4J Serie Manuel Du Propriétaire page 16

Connecting Hose to Water Tap
Connecting Screw-Type Hose to Tap
with Thread
Screw the hose connector onto the water supply
tap.
Connecting Screw-Type Hose to Tap
Without Thread
1
Loose the four fixing screws.
Upper
connector
Fixing screw
2
Remove the guide plate if the tap is too large
to fit the adapter.
Guide plate
16
3
Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws.
4
Push the supply hose vertically upwards
so that the rubber seal within the hose
can adhere completely to the tap and then
tighten it by screwing it to the right.
Connecting One Touch Type Hose to
Rubber
seal
Tap Without Thread
1
Unscrew the adapter ring plate and loose the
four fixing screws.
Plate
Supply
hose
Ring plate
EN