Cleaning - MAXXMEE 04067 Mode D'emploi

EN
6. Plug the connecting cable into the
plug socket.
7. Hang the balloon (1), with its zip
fastener at the front, on the clip and
close the zip fastener (Picture H).
Make sure that the balloon is pulled
over the end piece of the main unit.
Ironing
1. Pull the damp item of clothing onto
the balloon (Picture I). Important!
The sleeves of the balloon must be
placed in the sleeves of the item of
clothing until they poke out at the
ends. They must fit properly in the
sleeves of the item of clothing and
not be twisted or scrunched up.
2. If the item of clothing has buttons,
close them (also on the sleeves).
3. Spread the clamps (4) along the bot-
tom of the item of clothing (Picture J):
two at the back and three at the front
(one at the front in the middle on the
button strip). This weighs it down and
ensures it will not go out of shape
when the balloon is inflated.
4. Press the button
the device (Picture K).
The pressing time is set to 15 minutes
after switch-on. However, the length
of time can vary depending on the
textile type and level of moisture.
We recommend that you start with a
shorter time and extend it if neces-
sary.
L
For conventional, spun shirts
(1200 spins), an ironing time of
15 minutes is generally enough.
For damper or thicker textiles
(e.g. flannel shirts), it may be
necessary to increase the time to
30 or 45 minutes.
5. Press the button
increase the pressing time in 15-min-
ute increments (15 / 30 / 45 minutes).
14
04067_Inlay_de-en-nl-fr-es-it_A5_V2.indb 14 04067_Inlay_de-en-nl-fr-es-it_A5_V2.indb 14
(9) to switch on
repeatedly to
The control lamp next to the minute
indicator shows the chosen pressing
time.
6. Once the balloon has inflated,
straighten out the item of clothing
and smooth it down again.
7. When the set time elapses, the device
switches off automatically.
However, the device can be switched
off manually at any time by pressing
the button repeatedly.
8. Allow the item of clothing and the
clamps to cool down slightly, then
they can be removed.
L
Wide-apart buttons may result in
the button strip crimping slightly
during pressing. Here it is advis-
able to smooth down the button
strip again by hand immediately
after the pressing process.
9. Pull the mains plug out of the plug
socket and allow the device to cool
down completely.

CLEANING

Please Note!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
Wipe off any dirt from the device and ac-
cessories (including the balloon (1)) with
a damp cloth and a little mild cleaning
agent if required. Allow all parts to dry
completely before storing them away.
30.11.2020 12:09:24 30.11.2020 12:09:24