Evenflo Advanced Epic 4 Manuel D'utilisation page 4

ASSEMBLING YOUR STROLLER
3
For ease of removal and assembly of clevis pin, use needle nose pliers.
To assemble the rear wheels to the axle, remove clevis pin
and rear hub on the axle.
J
With the spokes facing out, slide a wheel
Insert straight side of clevis pin through hole in axle. Snap hub cap
Pull on wheel to make sure it is locked securely. Repeat steps to attach other rear wheel.
G
H
4
L
K
CLICK!
M
M
5
E
CLICK!
D
4
and one washer from axle, leaving one washer
G H
onto the axle. Slide on a second washer .
I H
onto wheel.
F
F G H I J H
Turn the stroller upside down, as shown, so the rear of the
stroller is facing upwards.
Hold the rear wheel/axle assembly so the brake levers
K
face toward the parent's handle.
Slide the rear wheel/axle assembly onto the stroller frame
until each side locks into place with audible clicks.
Pull upward on the rear wheel/axle assembly to make sure it is
locked securely.
Turn the stroller so the front of the stroller is facing
upwards, as shown.
Slide a front wheel assembly into the front frame
D
leg until it locks into place with an audible click.
E
Pull downward on the front wheel assembly to make
sure it is locked securely. Repeat for other side.
Turn the stroller right side up onto its wheels.
To remove, push metal button
and pull wheel off stroller.
C
6
P
CLICK!
7
L
M
S
T
C
ASSEMBLING YOUR STROLLER
Install the child's tray onto the tray mounts
P
the tray locks into position with audible clicks. Pull on the
child's tray to make sure it is locked into place.
Q
To install the canopy , stand behind the stroller and slide
R
each end of the canopy onto the canopy mounts
S
located on the stroller frame. Make sure each end of the
canopy slides onto the mounts completely.
R
. Make sure
Q
T
5