Publicité
Les langues disponibles
Les langues disponibles
C
2
Insert the appliance plug into the appliance.
3
Insert the mains plug into the wall socket.
The pilot light will go on to indicate that the appliance is charging.
B
This appliance is suitable for a mains voltage of 230V.
B
Only use the cord supplied with the appliance.
B
Do not charge the appliance for more than 24 hours.
A fully charged appliance has a cordless operating time of up to
50 minutes.
Optimising the lifetime of the battery
- After the appliance has been charged for the first time, do not
recharge it between clipping sessions. Continue using it and recharge
it only when the battery is (almost) empty.
- Discharge the battery completely twice a year by letting the motor
run until it stops.
- Do not keep the cord plugged into a wall socket all the time.
- If the appliance has not been used for a long period of time, it must
be recharged for 12 hours.
Corded clipping
To use the hair clipper connected to the mains:
Switch the hair clipper off, connect it to the mains and wait a few
seconds before switching it on.
If the battery is completely empty, wait a few minutes before switching
the appliance on.
Do not run the appliance from the mains when the battery is fully
charged.
Preparing for clipping
Also see the interactive instruction CD-ROM.
Clipping with comb attachment:
Select the small or large comb attachment, depending on the desired
hair length.
Hair length settings
C
The hair length settings are indicated in millimetres on the comb
sleeve.The settings correspond to the remaining hair length after
cutting.
- The small comb cuts hair to a length of 3 mm, 6 mm, 9 mm, 12 mm,
15 mm, 18 mm or 21 mm.
- The large comb cuts the hair to a length of 23 mm, 26 mm, 29 mm,
32 mm, 35 mm, 38 mm or 41 mm.
ENGLISH
5
Publicité
