Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ADJUSTMENT AND USE

Mounting Hardware and Adjustments.
WARNING: Adding additional links to the hardware may
reduce the overall strength.
IMPORTANT! After hardware and support pad positioning,
make sure that the teeth on all link joints are properly aligned and
engaged before final tightening. See the warning in the "Important
Safety Information" section in this manual.
H = Height
Loosen the bolt(s) and slide mounting link up and down on the
back support shell, mounting track, chair cane or wing slot.
D = Depth
Adjustable in multiple ways:
-
Loosen the bolts and slide the mounting link* in and out on the
back support shell or wing slot. This may also affect the width.
-
Loosen support pad mounting bolts under the support pad
cover, and slide the support pad along the slots.
-
Remove the bolts (under the cover, if applicable) and reattach
the bolts, using alternate threaded holes in the support pad.
W = Width
Loosen the bolts and rotate the hardware links.
* Note: Extra hardware links are available.
A = Angle
Adjustable in multiple ways:
-
Loosen the bolts (under the cover, if applicable) and tilt the
support pad up and down.
-
Loosen the bolt at the end of the support pad mounting link and
rotate the support pad.**
** Note: Gear tooth adjustment points are spring loaded for easy
adjustment. When the bolts are loosened, the spring will hold the
support pad and hardware in place while other areas are tightened.
Support Pad Adjustments
The moldable support pad can be shaped by hand or by bending it
over a stable surface.
Operating the Swing-Away Feature on the Mounting Hardware
To swing away the lateral support pad, press the silver release button (A), located on the underside of the assembly.
The assembly will snap back into place when it is returned to its original position. Before use, make sure that the assembly is engaged.
WARNING: If the assembly is not engaged, it will not be locked into place. If not locked, it will not provide the intended support.
Support Pad End
BodiLink on Permobil Corpus Operation Manual
Back Support Mounted End
A
10
Fixed Hardware with Support Pad (no cover)
H & D
W
D & A
A
Support Pad End
Back Support Mounted End
LTS

Publicité

Table des Matières
loading

Table des Matières