Bodilink Lateral Trunk Support; Lts; Support Pad Attachment - Permobil BodiLink Corpus Manuel D'utilisation

BodiLink Lateral Trunk Support

LTS

SUPPORT PAD ATTACHMENT

All required tools are provided.
1
If the support pad (E) has a cover, start by pulling back the
cover flap to expose the holes in the support pad. Line up the
bolts (B) and the safety washers (C) with the short slots on the
hardware link (D) and the holes inside the support pad (E). The
flat face of the link (D) must face the support pad.
2
Tighten the bolts (B) using the 4mm hex key.
Note: Follow these instructions if the support pad is already attached
to the hardware assembly (A), and depth adjustment of the support
pad is needed:
1
Pull back the cover flap. Loosen but do not remove the bolts (B)
using the 4mm hex key. Slide the support pad (E) into position.
2
Tighten the bolts (B) with the 4mm hex key and release the
cover flap.
BodiLink on Permobil Corpus Operation Manual
Note: The LTS support pad cover is not shown but may be
included with the support pad. See "Cleaning" for cover care .
Supportive Shape Support Pad
8
E
A
D
Swing-Away Hardware and
C
B