Signal Booster Specifications - weBoost Drive 3G-X Manuel

Signal Booster Specifications

Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Power output for single cell phone (dBm)
Power output for multiple received channels
(Uplink) dBm
Power output for multiple received channels
(Downlink) dBm
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the
rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This
power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The
Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes
it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the
power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, an
problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster's microprocessor.
Need help?
Typical
Maximum
Uplink
Downlink
No. Tones
2
3
4
5
6
No. Tones
2
3
4
5
6
http://cellphonesignalbooster.us
Drive 3G-X
460011
SMA
50 Ohms
824-894 MHz and 1850-1990 MHz
800 MHz
47.8
800 MHz
37.8
39.4
800 MHz
29.0
-7.9
800 MHz
26.7
23.2
20.7
18.8
17.2
800 MHz
-14.3
-17.8
-20.3
-22.3
-23.9
4 dB nominal
> 90 dB
12-15 V, 2 A (subject to uplink power)
1900 MHz
44.2
1900 MHz
79.4
80.4
1900 MHz
27.1
0.7
1900 MHz
24.2
20.6
18.1
16.2
14.6
1900 MHz
-15.5
-19.1
-21.6
-23.5
-25.1
11