Signal Booster Specifications - weBoost Signal 3G Manuel

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Signal Booster Specifications

Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Power output for single cell phone (dBm)
Power output for multiple received channels
(Uplink) dBm
Power output for multiple received channels
(Downlink) dBm
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of
authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is
too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band. For a
detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts,
any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing power from the Signal
Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
Need help?
800 MHz
13.4
800 MHz
Typical
41.7
Maximum
43.3
800 MHz
Uplink
Downlink
800 MHz
No. Tones
2
3
4
5
6
800 MHz
No. Tones
2
3
4
5
6
http://cellphonesignalbooster.us
Signal 3G™
460009
SMA-Female
50 Ohms
824-894 MHz & 1850-1995 MHz
23.8
-6.05
24.1
20.5
18.0
16.1
14.5
-3.2
-6.7
-9.2
-11.1
-12.7
4 dB (nominal)
> 60 dB
5V DC, 1A
1900 MHz
12.3
1900 MHz
84.1
88.9
1900 MHz
22.3
-6.3
1900 MHz
23.2
19.6
17.1
15.2
13.6
1900 MHz
-4.7
-8.2
-10.7
-12.7
-14.2
7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

470009

Table des Matières