weBoost Drive 3G-X Manuel page 4

Vehicle Roof
2. Run the Outside Antenna cable into
the car. The cable is strong enough
that it may be shut in most vehicle
doors without damaging the cable.
For a cleaner look, carefully pull down
the door seal, run the cable under
the seal, and push the seal back into
place. This method reduces wear
on the cable as the door opens and
closes.
3. Install the Low-Profile Inside Antenna.
• Identify a place on the right side of
the driver's seat to mount the Inside
Antenna. The location should be at
least 18 inches but no more than
36 inches from where the cellular
device will be used.
• Install the Inside Antenna at the
same angle as the cell phone when
held in use or near the laptop's
cellular data card to maximize signal
strength.
For a more professional look, you
can install the Inside Antenna
underneath a car seat cover or
upholstery.
• When you have tested the
functionality of your Signal Booster,
mount the Inside Antenna by peeling
off the backing of the Velcro
attach it to your selected location
on the seat and secure the Inside
Antenna.
4. Place and connect the Drive 3G-X
Signal Booster.
• Select a location for the Signal
Booster that is free from excessive
heat, direct sunlight and moisture
4
Need help?
From Inside
Note: The Drive 3G-X Signal Booster
may remain on, in vehicles whose 12V
DC power sources do not automatically
shutdown when the vehicle is turned
off. This could result in discharging the
vehicles battery in one to two days.
Note: Some 12V DC power sources are
shut down when the vehicle ignition is
turned to off. Refer to your vehicle owners
manual for specifics related to your
vehicle.
Note: The aluminum casing of your Signal
Booster will adjust to the temperature of its
and
®
environment, but is designed to protect the
Signal Booster technology. For example,
in the summer, the Signal Booster case
may be as hot as 150 degrees inside your
vehicle. These high temperatures will
NOT damage the Signal Booster, nor do
they pose a fire risk to the vehicle. Again,
be sure to place your Signal Booster in a
location with adequate ventilation and away
from direct sunlight or moisture.
http://cellphonesignalbooster.us
and that has proper ventilation.
Good locations include underneath
a seat or under the dashboard.
• Connect the wire from the Outside
Antenna to the port labeled "Outside
Antenna" on the Signal Booster.
Antenna
• Connect the wire from the Inside
Antenna to the port labeled "Inside
Antenna" on the Signal Booster.
• Plug the power adapter into
vehicle's 12V DC power supply
and attach the cord to the side of
Power Booster labeled "Power."
NOTE: Do NOT connect the power
to the Signal Booster until you have
connected both the Inside and
Outside Antennas.
• Power up your Signal Booster by
flipping the switch on the back o
the DC power adapter on. A red
light should appear on the power
adapter.
From Outside
Antenna
Power
Adapter