Understanding The Lights - weBoost Drive 3G-X Manuel

Troubleshooting &
Understanding Lights
The Signal Boost includes two indicator
lights on the front of the Drive 3G-X. The
indicator lights will either be green or red.
Green indicates that the booster is
powered and operating at maximum
gain.
Solid Red indicates that the booster
has shut off on the associated
frequencies to prevent oscillation
(feedback).
Green/red Blinking indicates that the
booster is operating at a reduced gain
to prevent oscillation (feedback).
Fixing Red Light Issues
If one or more lights on the Signal Boost
are red:
1. Make sure all connections are tight.
2. Increase the distance between the
outside antenna and the Drive 3G-X,
by moving them horizontally and/or
vertically farther apart until the light(s)
change to green. Remember to keep
the antenna at least 6 inches from
any window or sunroof.
3. Follow the same steps for a green/red
blinking light until the light goes solid
green.
4. If more separation is not possible and
the coverage of the booster is too
small with a green/red blinking light
indicating reduced gain, contact the
Customer Support Team for
assistance: ............
Need help?
.
http://cellphonesignalbooster.us
Lights Off
1. Check connections on the power
supply to see that it is firmly plugged
into both the Drive 3G-X and the
power source.
2. If using a DC power supply in your
vehicle, ensure the power supply is
properly inserted. Then check the
12 volt power from the car socket
and the fuse. Replace the fuse if
necessary.
3. If using a power strip in a building,
ensure the power strip is plugged
in and turned on and that power is
coming from the outlet.
NOTE: The Signal Booster can be reset by
disconnecting and reconnecting the power
supply.
Alternate Outside Antenna
Installation: NMO Mount
Select a location for mounting the antenna.
The best location would be centered on the
vehicle roof, although other locations are
acceptable.
Roof mount only: For mounting the
antenna to the roof of your vehicle, use
weBoost #905814 (3/8 in. w/RG58 cable)
or #907414 (3/8 in. w/RG174 cable), which
must be purchased separately (A). Drill a
hole in the desired location for mounting.
The size of the hole should be 3/8 in.
The plastic washer (B) should be placed
over the threads of the NMO mount (A).
From the inside of the vehicle, insert the
threaded portion of the mount up through
the hole in the vehicle.
From the top of the vehicle, screw the
threaded nut (D) onto the mount threads
coming up through the roof and tighten
until secure.
The black rubber washer (C) should now
be positioned around the threaded nut.
Working from the inside of the vehicle,
securely route and position the cable
provided.
5