AFG 5.9AE Manuel Du Propriétaire page 13

ASSEMBLY STEP 4
HARDWARE FOR STEP 4
PART TYPE
J BOLT
K SPRING WASHER
L FLAT WASHER
M WAVY WASHER
7
J
K
L
M
DESCRIPTION QTY
M8X1.25PX20L 2
8.2X15.4X2T 2
8.2X20.0X1.5T 2
17.2X22.5X0.5T 2
6
5
2
M
8
L
K
J
9
A Open HARDWARE FOR STEP 4.
B Carefully pull the CONSOLE CABLE (5) through the
CONSOLE MAST (6) using the twist tie located inside the
CONSOLE MAST (6).
C Attach CONSOLE MAST (6) to MAIN FRAME (2) using
PRE-INSTALLED BOLTS AND WASHERS (7).
D Slide WAVY WASHER (M) over CRANK (8) followed by
PEDAL ARM (9) as shown. Rest pedal arm wheel on guide rail.
E Attach the PEDAL ARM (9) to the CRANK (8) using 1 FLAT
WASHER (L), 1 SPRING WASHER (K) and 1 BOLT (J).
F Repeat steps D–E on the opposite side of the elliptical.
J
K
NOTE: Be careful not to pinch
any wires while attaching the
console mast.
M
L
13