Preparation Of Coffee - Isomac ALBA Notice D'emploi Et D'entretien

GB USA
• ALBA The heating element LED (3) will switch off and the
coffee LED (4) will switch on;
• TEA The heating element light (3) goes off and the coffee
light (4) goes on.
At this point the ALBA/TEA coffee machine is ready for use.
If the water in the tank should run out, the machine will switch itself off automatically.
ALBA
LEDs (2) and (7) will remain switched on;
TEA
All of the lights (2), (3), and (4) will switch off.
To start the machine again proceed as follows:
• switch off the machine with the main circuit breaker (1);
• unplug it;
• fill the tank with water;
• plug in the power cable;
• switch on the machine with the main circuit breaker (1);
ALBA
The machine on LED (2), heating element LED (3) and MAX water level LED (5) will switch on;
TEA The main power ON light (2) and the heating element light (3) will go on;
• wait about 3 - 4 minutes for the machine to be pressurized;
ALBA
The heating element LED (3) will switch off and the coffee LED (4) will switch on;
The heating element light (3) goes off and the coffee light (4) goes on.
TEA
4.2

Preparation of coffee

WARNING
Make sure the tank is always full of water!
• Make sure the machine is pressurized
(see paragraph 4.1);
• fill a one cup filter holder (8) if you want one cup of coffee or a
two cup filter holder if you want two cups at the same time, and
press the coffee slightly with the presser;
18
ALBA
ALBA
ALBA
TEA
Fig. E
TEA
Fig. F
TEA
Fig. G
ALBA - TEA