Fellowes PowerTrim A3 Mode D'emploi page 6

BEFORE TRIMMING
1.
Ensure the machine is on a stable surface. Check there
is enough clear space behind the machine to allow
trimmed items and off-cuts to pass through freely.
STEPS TO TRIM
3.
Switch the power on (Power switch located at the side
of the machine).
4.
The Cut-Control LED touch pad and the LED lights in
trimmer base will flash and light up.
5.
Insert document to trim. Use the Overload Protection
document gauge at the side of the cutting base to
check the thickness of items does not exceed maximum
capacity.
6.
Use transparent window with orange trimline guide
to quickly and accurately align your cuts. Align cut line
with the outer edge of the orange trimline. For best
results, mark the exact cut position on the item before
trimming and try trimming a test sheet.
7.
Alternatively, align item with the cut dimensions (A4,
photo etc.) on the base of the trimmer.
INTEGRATED CARRY POINTS
12.
6
PowerTrim_v2.0_All_Langs.indd 6
PowerTrim has an integrated carry point in the cutting base for safe and easy movement and
transport of the trimmer.
2.
Select the correct power lead for the appropriate power
supply. Fit the lead to the power converter and to the
machine (the socket is at the side of the machine). Plug
the machine (power converter) into an easily accessible
mains socket. Switch the mains supply on.
8.
Secure document with SafeCut™ Clamp and the Cut-
Control LED touch pad will light up blue.
9.
On pressing the Cut-Control LED touch pad, machine
will start to trim. When touched, the Cut-Control LED
will light up in purple and then turn flashing blue when
it is cutting.
10.
PowerTrim will complete 6 cut cycles for cutting max 30
sheets (80gsm).
The cutting can be stopped by pressing the Cut-Control
LED touch pad when cutting is in progress. Cutter will
then return to start position and scissor icon will light
up in solid blue.
11.
When cutting is complete, material will drop auto-
matically. Release clamping mechanism again before
removing items from cutting bed.
12/02/2009 13:59:45