Fellowes PowerTrim A3 Mode D'emploi page 5

TRIMMER CONTROLS
A On/off switch (at side)
B Cut-Control LED touch pad
™
C
SafeCut Clamp
D Carry point
FEATURES & TIPS
FEATURES
SafeCut™ Guard
Ensures that power supply is stopped when guard
is opened – for service and maintenance.
SafeCut™ Clamp
Ensures that paper is securely clamped before
trimming – trimmer won't cut when SafeCut™
Clamp is not closed.
Electric trimming
The ultimate trimming solution for safety and
comfort – PowerTrim Electric trimming.
Cut Control function
LED touch pad with Start-Stop function to start
and stop trimming . User can stop trimming if
finished before cycle of 6 cuts has ended.
Overload protection
Indicates maximum load capacity of trimmer to
prevent overloading.
WORLDWIDE WARRANTY
Fellowes warrants all parts of the trimmer to be free of defects in material and workmanship for 2 years from the date of
purchase by the original consumer. If any part is found to be defective during warranty period, your sale and exclusive remedy will
be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse,
mishandling or unauthorised repair. Any implied warranty, including that of merchantability or fitness for particular purpose,
is hereby limited in duration to the appropriate warranty period set forth above. In no event shall Fellowes be liable for any
consequential damages attributable to this product. This warranty gives you specific legal rights. You may have other legal rights
that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide, except where different
limitations, restrictions or conditions may be required by local law. For more details or to obtain services under this warranty,
please contact Fellowes or your dealer.
PowerTrim_v2.0_All_Langs.indd 5
E Overload protection - Paper gauge
F Illuminated LED cutting bed
G SafeCut™ Guard (at rear) to protect internal mechanism
- with power breaker (magnetic closure)
H Window for paper alignment
TIPS
• Always clamp paper down with SafeCut™ Clamp before
trimming.
• Make sure paper is properly adjusted.
• Replace blade unit every 5000 cuts and cutting strip every
1000 cuts or when showing signs of wear. Item number for
spare parts # 54125.
• Align cut line with the outer edge of the orange trimline.
For best results, mark the exact cut position on the item
before trimming and try trimming a test sheet.
• Please read these instructions before use.
5
12/02/2009 13:59:45