Selecting A Location And Connecting Input Power - Hobart Welding Products BETA-MIG 2250 Mode D'emploi

2-11. Selecting A Location And Connecting Input Power

18 in (457 mm) of
space for airflow
OM-192 440 Page 14
Y Do not move
or operate unit
where it could tip.
Y Always connect grounding
conductor first.
= GND/PE
1
5
L1
L2
2
4
3
L2
1 Rating Label
Supply correct input power.
2 Plug
3 Receptacle
Connect plug to receptacle.
4 Input And Grounding
Conductors
Connect directly to line disconnect
device if hard wiring is required.
5 Line Disconnect Device
See Section 2-10.
Y Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
L1
230 VAC, 1
ST-802 286