Volt-Ampere Curves; Installing Welding Gun - Hobart Welding Products BETA-MIG 2250 Mode D'emploi

2-3. Volt-Ampere Curves

2-4. Installing Welding Gun

1
OM-192 440 Page 10
3
2
4
Volt-ampere curves show minimum
and maximum voltage and amper-
age output capabilities of unit.
Curves of other settings fall be-
tween curves shown.
va_curve1 4/95 – SB-192 436
1 Drive Assembly
2 Gun Securing Thumbscrew
3 Gun End
Loosen thumbscrew. Insert gun
end through opening until it bottoms
against drive assembly. Tighten
thumbscrew.
4 Gun Trigger Leads
Insert leads, one at a time, through
small grommet on front panel. Con-
nect female friction terminals to
matching male terminals in unit.
Polarity is not important.
Close door.
Ref. ST-801 875