tiko Energy Solutions Bridge-Box Athos Mode D'emploi page 6

Bridge-Box User's Manual
Step 7 Put back the cover panel of the home distribution box to cover the elec-
trical contacts. Be sure that no electrical contact can be touched.
Step 8 Power on the system by enabling power in the electrical panel.
Step 9 To finalize the installation, all tiko devices must be configured using the
installation app.
Device Operation
The Bridge features one hardware push button:
• A single press generates a hardware reset.
• 10 times pressing at the speed of one press per second triggers a firmware up-
grade of the device.
Any further operation of the Bridge is subject to the control of the full system and oper-
ated by the Data Center through the Gateway (M-Box). No user interaction is required.
LED Explanation
The Bridge features two LEDs: a red LED at the top, and a green LED at the bottom.
•
In normal operation:
#
Top LED
Bottom LED
Bottom LED
Bottom LED
•
In firmware upgrade mode:
#
Top LED
Bottom LED
tiko Energy Solutions AG
Color
Steady Green
Steady Green
Yellow
Red
Color
Steady Green
Blinks Red @
0.5 Hz
English
Operation
Status
PLC connection ac-
tive
Device operational
PSU failure: running
in backup
Device POST failure
Status
Device is running a
firmware upgrade
Notes
incoming traffic in the last 60
seconds
Device Power-On Self-Test has
failed. Device requires service.
Notes
One blink each 2 seconds.
IM-0007-0002 Rev. 7
6 / 48