Qufora IrriSedo Klick Mode D'emploi page 6

EN
Filling the system with water
6. Open the grey catheter pouch and connect the catheter to the click tube while leaving
the catheter in the pouch - when you hear a click it is connected (6a). Take the catheter
out without touching the hydrophillic coating (6b).
7. Attach the catheter pouch to a surface somewhere near the toilet, using the sticky area.
8. Turn the control unit to position 1.
9. Hold the pump with the control unit pointing upwards (9a) and open the valve on the
water bag tube (9b). Squeeze the pump until it is full of water so that no air is left and
water comes out of the catheter (9c).
10. Pause the system by turning the control unit to the dot position between 1 and 2.
6a
9a
Using the system
11. Wet the catheter up to its base with tap water. It is now lubricated and ready to use.
12. Hang or place the water bag no higher than shoulder height relative to your sitting
position. You may use the supplied hook to hang the water bag on the wall. Now you
are able to instill water by using gravity or pump.
13. Sit on or over the toilet. If required, fasten the control unit to your thigh or wheelchair,
using the fixation straps.
14. Carefully insert the catheter into the rectum, supporting the catheter at its base.
Base
11
6
6b
Open
valve
9b
12
Sticky
area
7
9c
13
1
8
•
10
14