Bruno ELAN SRE-3050 Guide De L'utilisateur page 14

REMOTES
The SRE-3050 hand-held remote may experience certain types of interference caused
by portable and mobile radio frequency (RF) communications equipment. However, the
SRE-3050 uses infrared (IR) communications to minimize the possibility of interference.
Also, receivers are mounted on both sides of the SRE-3050 carriage to minimize interference.
Should interference occur, the unit will stop. This feature has been integrated into the
SRE-3050 to ensure your safety.
The direct line between the remote to either of the two (2) remotes should be clear of
obstacles for optimal operation. It may be necessary to reposition the remotes so that
they are aimed at the carriage.
To reduce the possibility of interference:
• While riding in the seat, ALWAYS operate the elevator using the UP / DOWN paddle
control on the armrest.
• Operating the SRE-3050 with a remote while riding in the seat can lead to signal
interference.
• DO NOT mount the remotes behind an obstacle such as a rail post or around a
corner.
• DO NOT allow direct sunlight to shine on the receivers (blinding the receivers on the
carriage).
• DO replace remote batteries regularly.
- Depleted or nearly-depleted batteries alter the effective range of the remote.
• DO keep the remote and receiver lens free of dirt and debris.
- Use a non-abrasive cleaner suitable for glass or acrylic surfaces.
- Do not use polishes or cleaning products containing wax. These products will
leave a film on the lens that will reduce the signal transmission range.
Remote Battery Replacement
To replace the batteries in the remotes, remove the access panel on the
back of the remote.
Two (2) AA alkaline batteries required.
Change batteries annually.
©Bruno Independent Living Aids, Inc.
14
®
SRE-3050 OPERATOR 02jan2021