KIRAMI MACU Mode D'emploi page 18

18/52
© Kirami Oy, Finland
Grates
A fire grate is installed to the heater, with one grill plate.
An air guide is installed to the top shelf which guides the fire air
circulation on the top part of the hearth. The heater must not be
used without these parts.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this
heater. The reduced end of the chimney fits inside the heater. The
chimney parts can be purchased separately in three different
lengths: 25 cm, 50 cm and 100 cm. There are also available
adjustable chimney corners and 100 cm long protective sleeves for
the lower part of the chimney.
We recommend a chimney kit for the heater. This package includes
200 cm chimney + 100cm protective sleeve and a standard hat.
There are also spark protective hats available for the chimney.
If you have purchased a chimney kit with the heater. It is supplied
in a separate box and has four parts (see picture right) and it has to be assembled.
Remove the protective film from the thermal protection and place the assembled chimney to the
chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use protective gloves!
Magnesium anode rod
Magnesium will work as anode, meaning that magnesium will corrode before
heater's aluminium does.
The mangesium rod should be replaced annually or after it has been
depleted. If the rod hasn't been changed on time the heater won't have
guarantee left.
Replacement instructions are on the replacement rod package.
NB! Before heating up check that the thread is waterproof. If water is
leaking through the thread then fasten it more and check that o-ring is in
place.
User manual: Kirami MACU Hot tub heater
Page 4
19.02.2020