User Instructions; Preliminary Test - Sensica ST050 Mode D'emploi

User Instructions

For use on facial areas,
specifically: "crow's feet",
"smile folds" and "eleven".
What to Expect
During your treatment it is
normal to experience:
• Sensations of warmth
created by the RF energy.
• Some mild red or pink color
on the skin – during and
just after each treatment.

Preliminary Test

The preliminary test is intended
to determine your skin's
reaction to the treatment and
help you find the best settings
for each treatment area.
Perform a preliminary test
on each area you intend to
treat 48 hours prior to the full
treatment.
• Prepare your skin as
described below in
Step 1: Prepare your skin.
Instructions for operating
the device can be found
below in Step 2: Device
operation.
12
• Before using the device,
apply an even layer of the
Base Gel on the treatment
area.
• Start your test with energy
level 1 and move the device
in small circular motions.
• Increase the energy levels
according to your comfort.
Stop the test if you do not
feel comfortable or if you
see adverse effects.
• Perform the preliminary test
for a total time of about 3
minutes.
• Wait 48 hours and examine
the tested area.
• If the skin in the tested area
appears normal and no
adverse effects are present,
you can proceed with a full
treatment at the highest
comfortable energy level
that you tested.
Note: You may select any RF
energy level that you find
comfortable. The RF energy
level indicates the rate at
which the temperature rises
when in heating mode. A high
RF energy level will enable
faster and more even heating.
You can achieve maximum