Serene Innovations CA-360Q Manuel D'utilisation page 22

FCC Part 68 Information and Rules
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the back of this equipment is
the format US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
The REN is used to determine the quantity of devices which may be
connected to the telephone line. Excessive REN's on the telephone
line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of the REN's should not
connected to the line, as determined by the total REN's contact the
local telephone company to determine the maximum REN for the
calling area.
This equipment cannot be used on the telephone company-provided
coin service. Connection to Party Line Service is subject to State
Tariffs.
If this equipment causes harm to the telephone network, the
telephone company will notify you in advance that temporary discon-
tinuance of service may be required. If advance notice isn't practical,
the telephone company will notify the customer as soon as possible.
if you believe it is necessary.
The telephone company may make changes in its facilities, equip-
ment, operations or procedures that could affect the operation of the
equipment. If this happens, the telephone company will provide
to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact:
Company Name : Serene Group, Inc.
Address: 14731 Carmenita Road, Norwark, CA. 90650 USA
Tel: 562-407-5400
Fax: 562-483-2087
If the trouble is causing harm to the telephone network, the
telephone company may request you to remove the equipment from
the network until the problem is resolved.
This equipment uses the following USOC jacks: RJ11C.
Copyright 2020 Serene Group, Inc. All rights reserved.
EN
22.