Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
System Reset
System Default on CA-360Q is Master Mode (M).
To change the system mode, it must go through a system reset. All
CA-360Q settings and paired accessories will be cleared.
Press SPK +
buttons for 2 seconds to initiate.
01.
The 1st level screen checks if still want to proceed,
Use
or
buttons to highlight the choice, press MODE to select:
Check Mark :
Yes - Go ahead with system reset.
"X" icon
:
No - Cancel system reset
Note: Press RESET can cancel at this time.
02.
A 2nd screen will appear, select the MAIN or SUB system mode.
Use or button to highlight, and press MODE
RESET will select the default selection "MAIN". (Master)
03.
System reset is complete. All previous accessories are cleared.
Note:
"MASTER" mode
"SUB" (remote) mode – triangle shaped
17.
– square shaped
www.sereneinnovations.com
Publicité
Chapitres
Table des Matières
