Serene Innovations CA-360Q Manuel D'utilisation page 20

I just bought an extra doorbell for my CA-360Q system, but it did
09.
not work. What do I need to do?
Ans: All new accessory devices must be learned or registered
by a CA-360Q master-unit before they can be worked or
recognized.
I bought four CA-360Q systems for my home. Can I combine
10.
them into a single system?
Ans: Yes you can. You need to convert three of the CA-360Q
units from "Master" Unit into a "Remote-Receiver" so they
can be learned (or registered) into the "Master" Unit.
11. How do I reset accessory's low battery icon on CA-360Q?
Ans: Press the RESET button for 6 seconds. This is only tempo-
rary. The low battery icon will appear again when the next
accessory low battery signal is received.
12. What caused this accessory's low battery icon to show?
Ans: This message is associated with registered sensor's
battery is either low, or not being turned on, or it may be
placed too far from CA-360Q. Turn on its power on move
the sensor closer to CA-360Q usually solve the issue.
13.
system. What should I do?
Ans:
press the test button on the accessory for at least 6
seconds when registering, until you hear CA-360Q sounds
14. I have a large home, can I use two or more CA-360Q to increase
coverage area?
Ans: Yes, CA-360Q and remote receivers has built-in repeater
functions. Each unit can relay the signal it received to the
next unit. This greatly increases effective coverage area.
15. Why is my CA-360Q displays "AX-0" ?
Ans: Your CA-360Q has enabled the "General CA-AX alerts"
function. It has detected a nearby CA-AX sensor signal not
part of its own. Refer to earlier section on general CA-AX
alerts.
Copyright 2020 Serene Group, Inc. All rights reserved.
EN
20.