Velux INTEGRA Solar DSL Instructions De Montage page 9

Registration of a solar product in more than
B
one remote control
One or more of the remote controls can be used for
simultaneous operation.
The example shows three solar products, a, b and c, where
all three products are to be registered in the remote control
from product c. In this way, remote control c can operate solar
products a and b as well.
The next two steps must be completed within
10 minutes:
1. Press RESET button at the back of remote controls a and b
for at least 10 seconds with a pointed object.
2. Press RESET button on the back of remote control c for
1 second.
The solar products a, b and c can now be operated via
remote control c.
Note: The solar products a and b can still be operated with
their respective remote controls.
Cancelling registration of a solar product
To remove the registration of a product in the remote control,
press button on the product (1) for 10 seconds (or until the
product starts running).
Note: The cancellation applies to all remote controls in which
the product has been registered.
6 VELUX ®
ENGLISH ENGLISH
Operation
C
Keys for operating the product
UP
DOWN
Short press: Product will travel to end position.
Long press: Product will travel until the key is released.
Stop key
B
Short press: Product stops.
Fitting of holder for remote control
D
Note: Before the holder is fixed to the wall, it is recommended
to check if the remote control is able to operate the relevant
products from the fixed position.
Fitting of remote control
E
If required, the remote control can be fixed to the holder as
shown.
Replacement of batteries
F
Insert new batteries (type AAA, 1.5 volt) as shown.
A
VELUX ® 7