Safety Instructions; General - Goobay 39511 Mode D'emploi

1

Safety Instructions

1.1

General

• Read the user manual completely and carefully before use.
The user manual is part of the product and contains important information
for correct use.
• Keep this user manual.
The user manual must be available for uncertainties and passing the pro-
duct.
• Use product, product parts and accessories only in perfect condition.
• Check regularly whether the device cable is still intact.
• Do not use the product if the cable is damaged.
• Compare the specifications of product and power supply.
They must be identical or be within the specified range.
• In case of questions, defects, mechanical damage, trouble and other
problems, non-recoverable by the documentation, contact your dealer
or producer.
Risk of electric shock
• In case of emergency, during thunderstorms and after use, pull the pro-
duct on its plug housing!
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
• Do not use the device with wet hands.
• Do not place the product near an open window.
Rain splashing on the fan may cause an electric shock.
• Secure packaging, small parts and insulation against accidental use.
• Operate the device only with the protective net closed and intact.
• Do not use the device if the protective net is damaged
• First switch off the device and unplug the mains plug before removing
the protective net.
• Always pull the product by the plug, not by the cable.
• Do not insert any fingers or objects through the protective net.
This can lead to injuries or damages to the device.
• Keep long hair and loose clothing away from the fan.
These can be sucked in by the air flow.
• Make sure that the fan is not near curtains or objects that can be pulled
into the fan.
• Do not operate the fan in the vicinity of explosive and/or flammable
gases.
• Do not place or operate the product near open flames, cooking or heat-
generating products such as radiators, heating registers and stoves.
Operation and storage conditions
• Place, install and transport product, product parts and accessories in a
safe way.
• During operation, place the product on a stable, level, dry and dust-free
surface so that it does not tilt during operation and the floor covering
cannot be damaged by vibrations.
• Avoid stresses such as heat and cold, moisture and direct sunlight,
microwaves, vibrations and mechanical pressure.
• Immediately disconnect the power plug if the product has become damp
or wet.
• Do not operate the product in dusty environments or with inadequate
ventilation.
13