Publicité
Les langues disponibles
Les langues disponibles
3. Unscrew the screws of the door bottom hinge.
4. Take off the appliance door by pulling it slightly
downwards.
5. Unscrew the top door hinge pin of the
appliance then screw it back on the other side.
6. Fit the appliance door on the upper door hinge
pin.
7. Remove the lower hinge. Put over the pin in the
direction of the arrow.
8. Unscrew and install the screw on the opposite
side.
9. Install the lower hinge on the opposite side
leaving the position of the door unchanged.
10. Screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces).
11. Remove and install the handle on the opposite
side.
46
2
1
4
1
CAUTION! Reposition, level the
appliance, wait for at least four hours
and then connect it to the power
socket.
Do a final check to make sure that:
•
All screws are tightened.
•
The magnetic seal adheres to the
cabinet.
•
The door opens and closes
correctly.
If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
ELECTRICAL CONNECTION
•
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
•
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
•
The manufacturer declines all responsibility if
the above safety precautions are not observed.
•
This appliance complies with the E.E.C.
Directives.
2
3
Publicité
