fluidra 74148 Manuel D'instructions page 23

6.2.1 button
Press to start the heat pump unit, the LED display shows the desired water temperature for 5 seconds, then shows the
inlet water temperature and the operation mode.
Press to stop the heat pump unit and show "OFF"
Notice : During the parameter checking and setting, press the
Press again to turn on/off the machine.
6.2.2 and
Clock/unclock the display:
Hold and
Water temperature setting :
or
Press
Water temp. setting range in Heating mode :6-41℃,
6.2.3 button
Parameter checking :
Press first, then press
Code Condition
d0 IPM mould temperature
d1 Inlet water temp.
d2 Outlet water temp.
d3 Ambient temp.
d4 Frequency limitation code
d5 Piping temp.
d6 Gas exhaust temperature
d7 Step of EEV
d8 Compressor running frequency
d9 Compressor current
d10 Current fan speed
d11 Error code for last time
Press first, then press
If needed, press
(for example: Press
or to adjust the parameter P7 Inlet water temp. Correction from -9 to 9.)
button
for 5 seconds to lock/Unlock the display.
to set the water temperature directly.
to check the " User parameter from d0 to d11
to check the " User parameter from P0 to P7
second, then press
first, then press
to quick-exit and save the current setting .
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 （rpm）
All error code
or to adjust the current parameter.
to enter parameter P7 checking, and press
19
Remark
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
N*5
Real testing value
Real testing value
Real testing value
second, then press