Krups DEFINITIVE Serie Mode D'emploi page 4

IFU_KR_CENTRIFUGEUSENC00118714_NC0011871429/03/1310:21Page3
POLARIZATION PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electrical shock, this plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not modify the plug in any way.
DESCRIPTION
A Pusher
B Feed tube
C Cover
D Stainless steel filter basket
E Juice collector
F Pouring spout with flow stop system
G Pulp collector
H Safety clamp
SAFETY SYSTEM
This appliance is fitted with a safety mechanism. To start the juice machine, the cover (C) must be
properly secured by the safety clamp (H). Opening the safety clamp (H) will stop the juice extractor.
At the end of a cycle, place the control switch (I) to OFF and wait until the stainless steel filter basket
(D) stops completely before removing the cover.
BEFORE FIRST USE
Unpack the appliance and place it on a solid, stable work surface.
Ensure that all packaging has been removed before starting the appliance.
We recommend that you wash all the removable parts (A, B,C, D, E, G, L, M, N) in warm soapy water
(see paragraph "Cleaning"). Before the first use rinse and dry them carefully.
USING THE APPLIANCE
Fit the juice collector (E) onto the appliance, tipping it slightly forward to pass the pouring spout through
the hole provided (see Fig. 1).
Place the stainless steel filter basket (D) in the juice collector (E). Ensure that the filter basket is properly
clipped onto the drive shaft (J). You can hear an audible click when it is positioned correctly (see Fig. 2).
Fit the cover (C) on the appliance with the ejection spout to the back (see Fig. 3).
Push the safety clamp (H) towards the back of the machine until it locks into place. You will hear an audible
"click" (see Fig. 4).
Fit the pulp collector (G) on the rear of the appliance (see Fig. 5).
Slide the pusher (A) into the feed tube (B) aligning the groove on the pusher with the small ridge in
the feed tube.
If you wish to separate the juice from the froth, slide the foam separator (M) in the juice container (N)
(see Fig. 6). The foam separator allows you to keep the froth inside the jug when you pour the juice
into a glass.
This appliance is fitted with a flow-stop system (F): push the pouring spout down to initiate the system
and allow the juice to flow out (see Fig. 7).
Place the juice jug (N) under the pouring spout in front of the appliance (see Fig. 8).
I
Control switch (2 speeds)
J
Drive shaft
K Motor unit
L
Juice container cover
M Foam separator
N Juice container
O Brush
P Cord storage
English
3