WALMEC TD3 PRO Instructions page 18

Installation photos
OPERATIONS
The TD -TD has the following two operating modes:
3 1
PRO PRO
- "PAINT and DRYING" mode: used when painting and drying;
- "SILICON GEL REGENERATION" mode: used when silicon gel is saturated and needs to be regenerated
(TD version only).
3
PRO
NB: painting or using TD
GETTING STARTED
To turn on the TD -TD
3
PRO
- turn the on selector to the "I" position: the selector will light
up GREEN;
- some test and welcome messages will appear on the screen
followed by the work screen.
1)
3)
output air are not possible in this phase.
3
PRO
(photo 6):
1
PRO
4)
17
2)
5)
6)