WALMEC TD3 PRO Instructions page 16

TD PRO TECHNICAL SPECIFICATIONS
1
Power: 220-240 Vac 50-60 Hz vers. 230 V - 100-130 Vac 50-60 Hz vers.115 V
Maximum power: 3000 W
Insulation: grounded metallic parts
Power adjustment system: TRIAC driven by electronic controller with built-in PID algorithm based on the thermocou-
ple in the heater
Maximum temperature control system on the resistances: TRIAC driven by thermocouple near the resistances;
safety thermostat
Electrical protections: 16A fuse, 500 mA, 6.3A for vers 230 V - 1A and 8A for vers 115 V
Admitted temperature field: from 19° to 70°C - from 66°F to 158°F
Maximum input pressure: 8 bar/116 PSI
Maximum flow: >1200 l/min @ 6 bar - > 42,37 cfm@87 PSI
PROPER USE
Walcom TD -TD is a professional system complete with air treatment for painting.
® 3 1
PRO PRO
It is made up of:
- a 25 micron filtering element with condensation centrifuge separator and automatic condensation drain (only TD )
3
PRO
- coalescent de-greaser filter with 0.01 micron mesh and manual oil drain (only TD )
3
PRO
- silica gel drying element (only TD )
3
PRO
- active carbon filtering element (only TD )
3
PRO
- heating element (TD -TD ).
3 1
PRO PRO
This system is designed to:
- treat normal mains compressed air to obtain the most suitable characteristics for painting,
- be installed, except for input and output compressed air hoses, out of explosive environments which in this
case include the spraybooths,
- be installed according to the instructions contained in this manual.
IMPROPER USE
Equipment use other than that described in the previous paragraph may lead to serious health hazards.
Specifically, the following may cause hazardous situations:
- the use of fluids other than normal compressed air,
- installation in explosive environments,
- installation according to criteria other than those indicated in this manual.
proper use improper use
15