WALMEC TD3 PRO Instructions page 15

control and
setting display
pressure
regulator
pressure
gauge
water
filter
oil
filter
TD PRO TECHNICAL SPECIFICATIONS
3
Power: 220-240 Vac 50-60 Hz vers. 230 V - 100-130 Vac 50-60 Hz vers.115 V
Maximum power: 3000 W
Insulation: grounded metallic parts
Power adjustment system: TRIAC driven by electronic controller with built-in PID algorithm based on the thermocou-
ple in the heater
Maximum temperature control system on the resistances: TRIAC driven by thermocouple near the resistances;
safety thermostat
Electrical protections: 16A fuse, 500 mA, 6.3A for vers 230 V - 1A and 8A for vers 115 V
Regeneration duration: Max 4 h.
Admitted temperature field: from 19° to 70°C - from 66°F to 158°F
Maximum input pressure: 8 bar/116 PSI
Maximum flow: >1200 l/min @ 6 bar - > 42,37 cfm@87 PSI
Air purification:
- first condensation separator stage with 25 micron mesh filter; automatic "heavy duty" condensation drain;
- second coalescent de-greaser stage with 0,01 micron mesh filter; 99,99999% solid particle retention
efficiency; <0.01 mg/m
- absorption dryer third stage with silica gel: <1.2% residual humidity; < -30°C dp - < -22°F dp output air dew point
temperature.
- active carbon fourth stage for gaseous pollutant removal such as oily fumes, hydrocarbons and odours;
<0.003 mg/m maximum oil residue; generates breathable air.
3
Working pressure regulation: membrane pressure regulator with pressure gauge downstream from filtering elements.
TD PRO
3
fault
on/off
signaller
switch
solenoid valve SRS
silica filter saturation
level indicators
maximum oil residue; manual oily condensate drain;
3
PID electronic
control panel
breathable air outlet
pressure
gauge
setting display
heater
element
active carbon filter
14
TD PRO
1
on/off
control and
switch
fault
signaller
PID electronic
control panel
pressure
gauge
heater
element