KRESS KUC60 Mode D'emploi page 9

WARNING! Your new Kress Rotary Hammer
Drill generates powerful forces to get your job
done quickly and effectively. These forces may cause
inferior quality SDS bits to break and jam in the chuck,
We therefore recommend that only high quality SDS
bits be used with this tool.
2. AUXILIARY HANDLE (SEE FIG. B)
Slide the handle onto the hammer and rotate to the
desired working position. To clamp the auxiliary handle
rotates the handle clockwise. To loosen the auxiliary
handle, rotate the handle counter-clockwise.
Warning: Always use the auxiliary handle.
3. ADJUSTABLE DEPTH GAUGE(SEE FIG. B)
Loosen the depth gauge by rotating the handle
counter-clockwise. Slide the depth gauge until the
distance between the depth gauge end and the drill
bit end is equal to the depth of hole/screw you wish
to make. Then clamp the depth gauge by rotating the
handle clockwise.
4. ON/OFF SWITCH (SEE FIG. C)
Depress the On/Off switch (5) to start and release it to
stop your tool.
— ON/OFF SWITCH WITH VARIABLE SPEED
CONTROL
Depress the On/Off switch to start and release it to
stop your tool. This tool has a variable speed switch
(5) that delivers higher speeds with increased trigger
pressure or delivers lower speeds with reduced trigger
pressure - speed is controlled by varying the pressure
applied to the switch.
5. SWITCH LOCK (SEE FIG. C)
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the direction of rotation control (6) in the center
position.
6. FORWARD AND REVERSE ROTATION CONTROL
(SEE FIG. C)
Forward rotation: Push the forward and reverse
rotation control to the left "
Reverse rotation: Push the forward and reverse
rotation control to the right "
drill bits.
WARNING: Never change the direction of
rotation while the tool is rotating, wait
until it has stopped.
7. FUNCTION MODE SELECTION (SEE FIG. D)
The operation of the gearbox for each application
is set with the function selector dial (4). To change
between functions, depress the unlocking button (a)
and rotate the selector to the desired operating mode.
", for drilling
" , for removing the
Mode for simultaneous drilling
and impacting of concrete,
Masonry
Mode for or drilling into steel,
wood and plastics
Mode for or chiseling
Mode for adjust the chuck angle
of chiseling
Note：Select this function mode
first , adjust the chuck angle to
desired direction. Then select the
function mode to "
the chiseling work.
WARNING: The operating mode selector
switch may be actuated only at a
standstill.
9. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve
the load on the machine immediately and allow cooling
for approx. 30 seconds at the highest no-load speed.
10. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for, the power tool cannot be
subject to overload. When the load is too high or the
allowable battery temperature of 75 °C is exceeded, the
electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
11. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging
by the "Discharging Protection System". When the
battery is empty, the machine is switched off by means
of a protective circuit: The inserted tool no longer
rotates.
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool
the motor. SDS-plus tungsten carbide drill bits should
always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Where possible use a pilot hole before drilling
a large diameter hole.
" , operate
9
EN