Makita DHP458 Manuel D'instruction page 10

1
2
012706
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
012707
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the
new ones and replace the carbon brush caps in reverse.
1
2
006304
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
Reinstall the rear cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1. Arm
2. Spring
3. Recessed part
3
1. Carbon brush
cap
1
1. Hole
2. Carbon brush
cap
OPTIONAL ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Drill bits
•
Hammer drill bits
•
Screw bits
•
Blow-out bulb
•
Safety goggles
•
Makita genuine battery and charger
•
Grip assembly
•
Depth rod
•
Hook
•
Rubber pad assembly
•
Wool bonnet
•
Foam polishing pad
•
Battery protector
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
10
or attachments
Only use accessory or
are