Zanussi ZOS35802XU Notice D'utilisation page 46

Clean all accessories after each use and let them dry. Use a soft cloth with warm water and
a mild detergent. Do not clean the accessories in a dishwasher.
Do not clean the non-stick accessories using abrasive cleaner or sharp-edged objects.
Accessories
11.2 How to remove: Shelf supports
Remove the shelf supports to clean the oven.
Step 1 Turn off the oven and wait until it is
cold.
Step 2 Pull the front of the shelf support
away from the side wall.
Step 3 Pull the rear end of the shelf support
away from the side wall and remove
it.
Step 4 Install the shelf supports in the oppo‐
site sequence.
The retaining pins on the telescopic
runners must point to the front.
11.3 How to clean: Water tank
Step 1 Turn off the oven.
Step 2 Place a deep pan below the steam inlet.
Step 3 Pour water into the water drawer: 850 ml. Add citric acid: 5 teaspoons. Wait for 60 min.
Step 4 Turn on the oven and set the function: True Fan + Steam. Set the temperature to 230 °C. Turn off
the oven after 25 min and wait until it is cold.
Step 5 Turn on the oven and set the function: True Fan + Steam. Set the temperature between 130 and
230 °C. Turn off the oven after 10 minutes and wait until it is cold.
To prevent limestone residue empty the water tank after each steam cooking.
Turn off the oven.
46 ENGLISH
When the cleaning ends:
Empty the water tank.
Refer to Daily use,
"Emptying the water
tank" chapter.
1
Rinse the water tank and clean
the remaining limestone residue
with a soft cloth.
2
Clean the drain pipe with
warm water and a mild
detergent.