How To Move The Machine - COMAC CM Mini Orbital Manuel D'utilisation Et D'entretien

1. The battery charge level indicator (1) is situated behind the battery support base. There are 3 LEDs which indicate the charge level of the
battery (Fig.1), one LED indicates the overcharge of the motor (2), the other LED (3) indicated that the machine is on and ready for use.
2. The overcharge LED (2) is connected to a circuit board which detects an overcharge superior to 8 seconds in duration and automatically
turns off the machine.
3. To turn the machine back on in case of overcharge, put the general switch in the "0" position and then put in the "1" position. If the circuit
board still detects an overcharge and turns off the machine, take the machine to an authorized service station to check.
1
1. CHARGE LEVEL
2. OVERCHARGE
3. ON/OFF
To move the machine, follow the instructions below:
1. Adjust the height of the handlebar by opening and closing the lever (1) situated on the handlebar as indicated in the figure (Fig.1)
2. Make sure the hook (2) is anchored in its compartment (Fig.2).
3. Incline the machine until the rear wheels touch the floor.
4. If you need to lift the machine, hold on to the anterior grip handle (1) and the upper grip handle (2) (Fig.4)..
ATTENTION: It is recommended to always wear protective gloves to prevent serious harm to the hands.
ATTENTION: To avoid damaging the power cord, disconnect the plug from the electrical outlet by pulling directly on the plug
and not on the power cord.
1
BATTERY CHARGE LEVEL INDICATOR
1

HOW TO MOVE THE MACHINE

1
2
2 3
1
2
2
26
1