Panasonic WH-UD03JE5 Serie Mode D'emploi page 18

Remote Controller buttons and display
1
Display
1 Mode selection
* * AUTO
1, 2
* * AUTO
1, 2
+ TANK
HEAT
HEAT
+ TANK
Operation icons
2
The status of operation is displayed.
Icon will not display (under operation OFF screen) whenever operation is OFF except weekly timer.
Holiday operation status
Zone: Room Thermostat
→Internal sensor status
Room Heater status
Bivalent status
(Boiler)
* The system is locked to operate without COOL mode. It can be unlocked only by authorised installers or our authorised service partners.
1
18
* Only displayed when COOL mode is unlocked (This means when COOL mode is available).
2
2
• Depending on the preset outdoor
temperature, the system selects
HEAT or * * COOL operation
1, 2
mode.
Auto Heat Auto Cool
• Depending on the preset outdoor
temperature, the system selects
HEAT + TANK or * * COOL +
1, 2
TANK operation mode.
Auto Heat Auto Cool
• HEAT operation is either turned
ON or OFF.
• The outdoor unit provides heat to
the system.
• The outdoor unit provides heat to
the water tank and the system.
• This mode can be selected only
when the water tank is installed.
Weekly Timer operation status
Powerful operation status
Tank Heater status
3 4
7
* * COOL • COOL operation is either turned
1, 2
• The outdoor unit provides cooling
* * COOL • The outdoor unit provides cooling
1, 2
+ TANK
• The outdoor unit provides heating
TANK • TANK operation is either turned
• The outdoor unit provides heat to
* The direction icons point to the currently
active mode.
5
6
ON or OFF.
to the system.
to the system.
when boiling tank.
ON or OFF.
the water tank.
• Room operation / Tank operation.
• Deice operation.
Quiet operation status
Demand Control or
SG ready or SHP status
Solar status